If you are experiencing hardware errors or failure, contact LaCie support for assistance. Additionally, removing, replacing or changing any part in the enclosure or, performing any action that involves the components in the enclosure, voids the product’s warranty. Removing the cover voids your product’s warranty. The components inside the chassis are NOT hot-swappable and are NOT serviceable at any location outside of LaCie-approved service centers. LaCie 2big RAID enclosure: non-serviceable components You can continue to use the LaCie 2big RAID storage but performance is reduced until the synchronization is complete. When replacing hard drives that are members of an active RAID array, the hard drive LEDs blink red and blue indicating that the RAID is synchronizing data. Gently push the disk tray handle until you feel it snap into place. Carefully insert the full disk tray into the empty disk slot.Forcing the screws too tight into the slots can make it difficult to remove them later and strip the screws’ teeth. Using a Phillips head screwdriver, carefully fasten all four screws into their four slots.The four screw slots should align with the disk’s four screw holes. Ensure the SATA connector is on the left. With its label side facing up, gently place the hard disk within the disk tray. This should also be considered more as a maintenance task than a disk space saving the task. Many disks have a label on one side and the printed circuit board on the opposite side. Run maintenance utilities Download for Mac also available in the Mac App Store Free system maintenance utilities like EaseUS CleanGenius can help clean up Mac temporary files, system caches and logs.Place the empty disk tray onto a flat work area with the handle on the bottom left.Using a Phillips head screwdriver, carefully unfasten all four screws from their four slots. ![]() Continue here if you are replacing the hard drive using the same disk tray.
0 Comments
Leave a Reply. |